-
Collectionnew
-
Installation
-
Tuesday, February 19, 2019
Installation Instruction
Read moreRemoving the tow point cover before installation, most of the cover can be removed by pushing in or pried. Only some special vehicles' tow point is covered by the bumper grille. In this case, the grille will need to need to be removed, or modification of hole drilling may be required.
Clean up the tow point before inserting the Tow Hook Adaptor Bolt (5) and tighten with 17MM wrench (Max 60LB/FT & do NOT use air tool). Some vehicles contain left-hand thread tow bolt.
Place the rubber washer (4) in between of the oval Shape Adaptor (2) and Tow Hook Bolt (5), *7MM Spacer (3) is optional*. Then use the Hex Wrench (7) slightly tight down the Long M8 Screw (8). DO NOT place the rubber washer (4) between the Long M8 Bolt (8) & Oval Shape Adaptor (2)...
-
-
Hot item
- About usour team
- Contact us
